RigExpert TI-3000 is a new and powerful USB transceiver interface based on high-quality stereo codec IC, for operating phone, CW and digital modes using a personal computer.
All in one through a single USB port. Ideal interface for FT8 and WSJT modes!
Ask your RigExpert distributor or reseller to provide pre-built cable for your new TI-3000 to connect it with your favorite transceiver. Or construct a cable yourself, using the diagrams published on our website here.
Or use the cable you already have.
Transceiver audio interface
Analog audio interface is a connection to transceiver audio output (external speaker connector or line output) and transceiver audio input (microphone connector or line input). Audio interface enables operating digital modes, as well as other useful functions (such as measuring levels of a signal from the air) by using a computer. Input (two channels) and output volume levels are adjusted by potentiometers on the front panel of the device.
CAT interface for various transceiver models
CAT (Computer Aided Transceiver) system provides control of transceiver frequency, operating mode and other functions by computer software. Normally, modern transceivers have serial (with various signal levels) link providing CAT interface. In RigExpert TI-3000, CAT interface port is recognized as a COM port by computer software.
PTT and CW output functions
Transceivers provide PTT (Push To Talk) and CW (Continuous Wave) keyer inputs to allow setting the transmitter on or off. In RigExpert TI-3000, PTT and CW outputs are assigned to the RTS and DTR lines of a separate COM port.
Compatible with any HAM Radio software: MixW, MMTTY, WSJT, etc.
The W8S DXpedition to Swains Island in the Pacific, set to take place in mid-March, has been postponed until fall as a result of travel restrictions i… Read more
AMSAT reports that the pioneering AMSAT-OSCAR 85 (AO-85) CubeSat, also known as Fox-1A, has gone silent. “Having not been heard throughout the most re… Read more