New tinySA is here!

The tinySA is a small spectrum analyzer, primarily intended for 0.1MHz to 350MHz input but it has some nice other capabilities:

  • Spectrum Analyzer with two inputs, high quality MF/HF/VHF input for 0.1MHZ-350MHz, lesser quality UHF input for 240MHz-960MHz.
  • Switchable resolution bandpass filters for both ranges between 2.6kHz and 640kHz
  • Color display showing 290 scan points covering up to the full low or high frequency range.
  • Input Step attenuator from 0dB to 31dB for the MF/HF/VHF input.
  • When not used as Spectrum Analyzer it can be used as Signal Generator, MF/HF/VHF sinus output between 0.1MHZ-350MHz, UHF square wave output between 240MHz-960MHz.
  • A built-in calibration signal generator that is used for automatic self test and low input calibration.
  • Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer
  • Rechargeable battery allowing a minimum of at least 2 hours portable use
  • Due to the low cost and very small form factor there are certain relevant limitations.

Antenna


Review



Equipment

Diamond CX-210N

Diamond CX-210N

The Diamond CX-210N is a low loss, two position coaxial switch providing very low loss and high isolation. It is rated DC to 3000 MHz and can handle u… Read more


News

The post New tinySA is here! appeared first on QRZ NOW – Ham Radio News.

Leave a Reply